2001 Update on Powdery Mildew Control

September 7, 2001 - 07:47

Powdery mildew diseases cause serious damage to many floral and ornamental crops in nurseries, greenhouses and landscapes both outdoors and indoors. The diseases are very similar, with symptoms initially appearing as small, white, powdery or dusty colonies (1/4 to 1/2 inch) that form in circular patches on upper or lower sides of leaves, stems, petioles and even flower petals (see Figure 1). In severe infections, the entire leaf surface can become covered with the white spores (conidia) of the fungal pathogen. Curling and distortion can occur when leaves are severely infected with powdery mildew. Sometimes conditions are not good for spore development and symptoms are confined to purplish or reddish discoloration (see Figure 2). This symptom can be confused with nutrient deficiency, phytotoxicity or, on some plants, chilling injury. Early infections are easy to miss unless plants are carefully examined at least once a week.

Although the names sound similar, powdery mildews are not closely related to the downy mildews, which are related to pythium and phytophthora. Powdery mildew diseases are similar to each other in many respects. However, the species that infects rose will not infect African violet – thus some powdery mildew diseases are specific to a single crop or group of closely related plants. In contrast, the species that attacks Gerber daisy (Erysiphe cichoracearum) also attacks the plants listed in Table 1 and a multitude of others. This can make prevention of powdery mildew a challenge for growers producing a large variety of ornamental crops.

Powdery mildew fungi (oidium, sphaerotheca and erysiphe) are obligate parasites that cannot live in the absence of a plant host. It is sometimes possible to eradicate the pathogen from a growing area when the crop it has been infecting is removed. However, leaving even one apparently healthy plant makes it possible for the powdery mildew fungus to survive. This is further complicated when the host range is wide, such as that described for E. cichoracearum. It is rarely practical to eliminate all host plants from a greenhouse or landscape. The list of hosts for this powdery mildew includes a wide range of common weeds that can serve as inoculum reservoirs even in the absence of a cultivated host.

Conditions favoring powdery mildew diseases are very similar and some generalizations can be made regarding their control. Low to moderate relative humidities and moderate temperatures favor powdery mildew fungi. However, not all will appear at the same time, since each has its personal preference for humidity and temperature. In California, hydrangeas with powdery mildew are often found in the fall while crape myrtle powdery mildew occurs earlier in the summer or even the spring. Sometimes the stage of the crop is most important. Poinsettia powdery mildew, for example, generally appears during the final stage when the plant canopy is dense and the relative humidity is ideal. In any event, all powdery mildew diseases do not appear simultaneously in a single environment and scouting year-round is advisable.

Disease control strategies remain the same for most ornamentals. The most important method is careful examination of new plants as they come into a growing range. Maintain a strict scouting and roguing program to identify and destroy disease outbreaks before they become widespread.

Fungicide Update

The first recorded fungicide applied to control powdery mildew was a combination of sulfur and soap in 1824. Since that time, many other chemicals have been developed for control of powdery mildews. Benzimidazoles (such as benomyl) were introduced in the late 1960s. Benomyl was a widely used powdery mildew fungicide that had problems with resistance development soon after its introduction. This has also been seen occasionally with the benzimidazole fungicides still in use on ornamentals. One of the biggest breakthroughs in products for powdery mildew came when the triazoles were introduced in the late 1970s and throughout the past 20 years.

The most recent introduction is the strobilurin chemistry. Some of these products work primarily for powdery mildew diseases while others are broad-spectrum and can be used for many foliar and some soil-borne pathogens. It is interesting that some of the most recent techniques used to control powdery mildews in modern production of floral crops are soap products applied as sprays, and elemental sulfur applied by heating as a vapor (in enclosed structures like greenhouses).

Rotation of products is a special concern for any disease caused by a fungus that makes as many spores as powdery mildew fungi. Resistance development is common in this group. The products listed in Table 2 are in a number of different Á chemical classes and switching from one to another would be an effective rotation. The letter grades in the table indicate the relative effectiveness we saw in our trials and are not a compilation of other researcher trials. I have used the typical grading system we are all familiar with from our school days; thus the difference between an "A" and "A-" is slight but significant. In many situations, use of a "B" product will give good control of the powdery mildew disease. In other diseases that might be more damaging to the crop, or if the disease is not detected early, you should consider use of an "A" product. Those products that received less than a "B" would best be used for the main target disease with the knowledge that some powdery mildew suppression will occur as well.

It appears to be critical to use wetting agents with some of these products to improve their ability to control powdery mildew diseases. We have been able to demonstrate the benefits of using a nonionic surfactant with certain strobilurins (Compass and Heritage). Since their labels dictate use of these additives, it is a necessary as well as beneficial precaution. Be sure to read fungicide labels completely prior to use since they change periodically. There is a remarkable range of products available for use on powdery mildew diseases on ornamentals. Wise use according to the label will prolong the benefits these products afford.

Editor's Note: The use of specific trade names in this publication does not constitute endorsement of these products in preference to others containing the same active ingredients. The use of trade names is solely for the purpose of providing specific information and does not signify that they are approved to the exclusion of others. Mention of a product does not constitute a guarantee or warranty of the product by the author or magazine.

 

A.R. Chase is a plant pathologist and president of Chase Research Gardens Inc., Mt. Aukum, Calif. Further information on disease control is available at www. chaseresearchgardens.com.

About The Author

A.R. Chase will be speaking about powdery mildew and other greenhouse crop diseases at the FarWest Conference and Trade Show in Portland, Ore., August 23, 2001. This special session, sponsored by GPN and Syngenta, will be free of charge to those registered for the conference. For more information, call (847)391-1004.

Leave A Comment

  • Web page addresses and e-mail addresses turn into links automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd>
  • Lines and paragraphs break automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.
Email Subscriptions