Black-Eyed Susan: A Novelty Potted Plant

December 3, 2001 - 11:57

Rudbeckia, or black-eyed susan, is a well-known perennial garden plant. The two most commonly grown species are Rudbeckia fulgida and Rudbeckia hirta. R. fulgida is a perennial herb that grows to a height of at least 24-30 inches; R. hirta is often treated as an annual because it rarely survives cold winters and readily reseeds itself. Several dwarf R. hirta cultivars such as ‘Becky Mix’, ‘Sonora’ and ‘Toto’ are now available. The height of these dwarf cultivars is 10-15 inches and expected production time is between 12 and 16 weeks. Many perennials sold as flowering house plants perform well when planted outside in full bloom. An alternative is to market dwarf R. hirta as a flowering potted plant and then later plant it outdoors as a bedding plant.


UNIFORMITY AND QUALITY


Plant growth regulators such as B-Nine, Cycocel and Bonzi improve crop uniformity, marketability and overall plant quality of many floral crops. Due to environmental concerns, health risks and costs, attempts are emphasized to decrease the use of growth regulators and other chemicals. Environmental management may be used, for instance, to enhance greenhouse crop performance. Close temperature monitoring, including the relationship between day and night (DIF), is commonly used to control plant height. However, correctly used growth regulators remain effective height management tools when other methods are inadequate, impractical or unavailable.


Application techniques and strategies are continuously developed, researched and tested to improve efficiency at a reduced rate or amount of a growth regulator. As an example, promising results have been recorded with applications directly to the surface of the medium prior to planting. The growth regulator becomes available to the roots as plants are irrigated and the substance moves down through the medium. Compared to a traditional drench or spray application, the media spray technique is less labor-intensive. In addition, the application rate can be reduced, and the growth regulator is more efficiently utilized with decreased risk for plant injury or phytotoxicity.


In some floral crops, the development of lower buds is suppressed and held back while the top flower is developing. Removing the top growing point (pinching) early in production promotes the development and uniformity of all shoots and flowers on a plant. Taking the top flower bud off at a stage when the bud is half an inch or smaller allows the lower flowers to develop and open at a similar time. This method is sometimes called center budding and is commonly used for the uniform flower development of, for instance, daisy-type chrysanthemums.


Since dwarf rudbeckia cultivars are relatively new on the market, the response to specific production techniques and growth regulators for potted plant production is not known. B-Nine has earlier been reported effective for controlling height of rudbeckia Á while Cycocel was ineffective. Information on the efficacy of other commonly used growth regulators is not available for R. hirta. This study was therefore initiated to evaluate growth regulators, pinching and center budding for the development and flowering of dwarf R. hirta.


EXPERIMENT CONDITIONS


Seed of the cultivar ‘Toto’ germinated at 68 ± 4° F. Seven weeks after seeding, plants with 7-8 expanded leaves were transplanted into 4-inch pots filled with Premier Pro-Mix BX (Premier Horticulture; Premier Brands, Inc., Red Hill, Pa.). The plants were grown in a greenhouse with a polycarbonate covering at a spacing of four pots per sq. ft. High-pressure sodium lamps supplemented natural light to provide 16 hours of light each day. The daily light at the height of the plants was approximately 7.2 mol·d-1·m-2 or about 600-650 foot-candles throughout the 16 hours. Temperature was maintained at a constant 64 ± 4° F. Plants were watered once per day with a fertilizer solution of 100 ppm nitrogen using Peters’ 15-16-17 (The Scotts Company, Marysville, Ohio).


The growth regulators tested were Bonzi, Sumagic and B-Nine. Bonzi and Sumagic were used as plant sprays or sprayed directly to the surface of the growing medium immediately prior to planting as a media spray. Since B-Nine is not effective as a drench or when applied to the surface of the medium, B-Nine was only used as a plant spray. In addition, pinching and center budding were compared to the use of growth regulators.


Bonzi at a rate of 20 ppm and Sumagic at 10 ppm were used for both media and plant applications. The rate of B-Nine was 5,000 ppm. The media surface of each pot (12.2 sq. in.) was treated with a 0.054-fluid ounce solution resulting in 0.032 milligrams (mg) active ingredient (a.i.) Bonzi and 0.016 mg a.i. Á Sumagic per pot. The rate of 0.054 fluid ounces per pot was based on the recommendation to use two quarts per 100 sq. ft. For plant sprays, a 0.34-fluid ounce solution was used for each plant, resulting in 0.2 mg a.i. Bonzi, 0.1 mg a.i. Sumagic or 50 mg a.i. B-Nine per plant.


RESULTS


Pinched plants had the top bud and stem above the most recently fully expanded leaf removed two weeks following transplant. At the time of pinch, the plants had on average of 14 leaves and a plant height of 2.4-2.8 inches. Center budded plants had the top flower bud removed at the bud size of 0.2-0.4 inches seven weeks from transplant.


Time to the first and third open flowers was recorded as days from seeding. Plant height, plant width, flower and bud number were documented for individual plants as they reached flowering. Height was measured from the surface of the growing medium to the tallest point of the plant and the width as the diameter across the plant.


Average height of untreated plants was 9.5 inches (Figure 1). There was no significant difference in height between the control plants and those with the top flower bud removed (center budding). Pinching reduced overall plant height at flowering by an average of 0.8 inches. Plants sprayed with Sumagic were shortest with an average height of seven inches. B-Nine and Bonzi applied as plant sprays and Bonzi and Sumagic as media applications resulted in plants with a similar plant height of eight inches at flowering.


The untreated control plants had one open flower after an average of 110 days from seeding (Figure 2). The development and flowering of black-eyed susan is highly dependent on light conditions. Flowering was relatively slow in this study and an increased light intensity is expected to result in faster development. Removing the top flower bud (center budding) did not affect the time the first or the following two flowers opened, compared to control plants. Pinching or growth regulator application delayed the opening of the first flower by 4-5 days.


The shoot and flower development of each individual plant varied with the method of growth regulator application (Figure 2). Plants sprayed with growth regulator had slower development by approximately seven days compared to the opening of the first three flowers. Black-eyed susan receiving a media spray of growth regulator developed three open flowers at the same time as the control plants. Pinching the plants Á resulted in faster opening of the first three flowers by four days compared to the untreated control plants. The difference in rate of flowering (three open flowers) among pinched plants and those treated with a media application or center budding was too small to be statistically significant.


CONCLUSIONS


Only one application rate was included in this study for each growth regulator. The most efficient application for reducing overall plant height was the plant spray application of Sumagic (Figure 1). To produce R. hirta with a height similar to those treated with Sumagic, the other growth regulators may need to be applied at a higher rate. There was no delay in development and flowering for plants treated with a growth regulator in the form of a spray to the media surface. These media spray results are promising for getting good control of plant height with only one growth regulator application at a considerably lower rate than required for a plant spray.


Center budding did not affect height, overall flower development, plant uniformity or quality compared to untreated control plants (Figures 1 and 2). Therefore, removing the apical flower bud appears inefficient and unnecessary in dwarf black-eyed susan production. Pinching produced the most uniform flower development and is beneficial to achieve high-quality potted R. hirta. Due to the limited height reduction, however, pinching may need to be combined with a growth regulator application or other production technique such as DIF to result in a well-proportioned, containerized R. hirta ‘Toto’.

 


Editor’s Note: The use of specific trade names in this publication does not constitute endorsement of these products in preference to others containing the same active ingredients. The use of trade names is solely for the purpose of providing specific information and does not signify that they are approved to the exclusion of others. Mention of a product does not constitute a guarantee or warranty of the product by the author or magazine.

About The Author

Meriam Karlsson is associate professor of horticulture at the University of Alaska Fairbanks. She may be reached via phone at (907) 474-7005 or via E-mail at ffmgk@uaf.edu.

Leave A Comment

  • Web page addresses and e-mail addresses turn into links automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <code> <ul> <ol> <li> <dl> <dt> <dd>
  • Lines and paragraphs break automatically.

More information about formatting options

By submitting this form, you accept the Mollom privacy policy.
Email Subscriptions